High-temperature equipment lining
Equipment running well above ambient strips standard immersion linings, exposing bare steel to corrosion and process attack.
What is failing
Equipment running well above ambient strips standard immersion linings off the wall. The lining softens, blisters, or disbonds, and bare steel goes back into contact with the process. Corrosion and erosion attack the substrate, thinning the shell and shortening the run between turnarounds.
How CM Solutions US does it
CM Solutions US lines hot process equipment with ceramic-filled coatings matched to the actual service temperature, not a generic rating. We grit-blast the interior to a clean profile, then trowel or spray the lining during the outage. It cures cold inside the unit, so there is no oven and no hot work.
The vessel goes back into hot service with a lining built for its real operating temperature. Wall loss slows and the asset runs the full interval between turnarounds.
How CM Solutions US delivers it
CM Solutions US performs High-temperature equipment lining work for Oil & Gas, Petrochemical & Chemical, and Power Generation operations across Mount Jackson and the Mid-Atlantic, cold-applied and in place wherever possible, on your turnaround schedule. Crews are factory-trained Belzona applicators, the repair system is matched to the service conditions it will see, and urgent failures are covered by 24-hour on-call response. The result is a permanent, engineered repair that returns the asset to service without the cost or downtime of full replacement.
Related applications
Have equipment that needs to stay in service?
Tell us what is failing. We respond quickly, and we offer 24-hour on-call service.