Mining, Quarrying & Bulk Materials Coating & Repair Services

Sliding bulk material wears through chute walls, hopper throats, silo interiors, and mill liners. It hits hardest where flow changes direction and impact concentrates. Once the plate thins, you are running on a clock toward a hole and an unscheduled stop. CM Solutions US lines these surfaces with cold-applied ceramic-filled coatings. We size the coating to the particle and the flow path, building thickness back where the wear is worst. The same approach handles cyclones and separators. There, swirling particle-laden gas erodes cone walls and vortex finders until capture efficiency drops. The lining goes on in the maintenance window. No welding, no plate fabrication. The transfer point recoats and the structure goes back into service. We never cut a new section in. That extends plate life between changeouts. It keeps the wear concentrated in a renewable layer instead of the host steel.

Conveyor belts take gouges, rips, and worn top covers. The damage lets cargo escape and spread along the line until the belt is scrapped or the run stops. Rubber linings on chutes, hoppers, and slurry equipment strip off the same way. That exposes bare steel to fast metal loss. Pulling a belt for splicing means downtime the schedule cannot absorb. Sending a part out for re-lining costs the same time. CM Solutions US rebuilds the damaged belt area cold with a flexible elastomer. It bonds to the existing rubber, so the line returns to service with no splice and no belt replacement. We recoat and rebuild rubber linings in place on the structure as well. That renews abrasion protection without removing the part. The repair flexes and wears with the surface it sits on. That is what keeps it bonded under impact.

Abrasive slurry erodes pump impellers, casings, agitators, and mixer blades. It pulls the unit off its head curve and drops efficiency long before the bearings give out. Wear plates and bars in chutes and crushers lose thickness to impact and sliding abrasion. They then sit loose against an irregular backing. Steel shims leave only point contact, and the plate distorts within a shift. CM Solutions US rebuilds eroded vane and casing geometry. We overcoat it with an erosion-resistant ceramic layer. The pump returns to its rated profile with no weld heat and no rebalancing. For wear plates, we rebuild the worn face. Then we bed the plate to full bearing with a cold-cure compound poured to fill the gap. The plate seats flat and carries load across its whole area. It lasts longer between changeouts because nothing is riding on a high spot.

Bulk sites run on overhead cranes and elevated access. Both turn hazardous as they wear. Steel shimming under crane rails leaves point contact. That point contact fatigues the rail and the supporting structure under heavy wheel loads. Walkways, stair treads, and platform decks lose slip resistance to spilled fines, oil tracking, and worn aggregate. That raises fall risk in exactly the spots crews stand to work. CM Solutions US pours a cold-cure chocking compound that beds the crane rail across its full contact area and absorbs shock. The track carries heavy-lift loads without machining the support. On access surfaces, we apply safety-grip coatings to floors, stairs, ramps, and platforms. They reopen to foot traffic the same shift. The outcome across the plant is the same. More material moves between outages, with fewer emergency stops. Equipment holds its dimension and its footing under load. Our crew stays on call when a transfer point or belt fails between shifts.